Installation Instructions
InStaLLIng tHE WaSHEr
1.Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog the water valve screens.
2.Remove the inlet hoses from the plastic bag. Remove black rubber washers from bag and insert into hose fitting before connecting to unit.
3.(90° elbow end)
Carefully connect the inlet
hose marked HOT to the outside “H” outlet of the water valve. Tighten by hand; then tighten another 2/3 turn with pliers. Carefully connect the other inlet hose to the inside “C” outlet of the water valve. Tighten by hand; then
tighten another 2/3 turn with pliers. Do not
4.Connect the inlet hose ends to the HOT and COLD water faucets tightly by hand; then tighten another 2/3 turn with pliers. Turn the water on and check for leaks.
5.Carefully move the washer to its final location. Gently rock the washer into position. It is important not to damage the rubber leveling legs when moving your washer
to its final location. Damaged legs can increase washer vibration. It may be helpful to spray window cleaner on the floor to help move your washer into its final position. nOtE: to reduce vibration, ensure that all four rubber leveling legs are firmly touching the floor. Push and pull on the back right and then back left of your washer.
nOtE: Do not use the dispenser drawer or door to lift the washer.
nOtE: If you are installing into a drain pan, you can use a
6. With the washer in its final position, place a level on top of the washer (if the washer is installed under a counter, the washer
should not be able to rock). Adjust the front
leveling legs up or down to ensure the washer is resting solidly. Turn the locknuts on each leg up toward the base of the washer and snug with a wrench.
nOtE: Keep the leg extension at a minimum to prevent excessive vibration. the farther out the legs are extended, the more the washer will vibrate.
If the floor is not level or is damaged, you may have to extend the rear leveling legs.
17
