Installation Instructions
UnPaCKIng tHE WaSHEr
WarnIng: Recycle or destroy the carton and plastic bags after the washer is unpacked. Make materials inaccessible to children. Children might use them for play. Cartons covered with rugs, bedspreads or plastic sheets can become airtight chambers causing suffocation.
1.Cut and remove all packaging straps.
2.While it is in the carton, carefully lay the washer on its side. DO NOT lay the washer on its front or back.
3.Turn down the bottom flaps. Remove all base packaging including the styrofoam base.
4.Carefully return the washer to an upright position and remove the carton by lifting it upward.
5.Carefully move the washer to within 4 feet (122cm) of the final location.
6.Remove the following from the back side of the washer: 4 bolts
4 plastic spacers (including rubber grommets)
Do not remove screw or clip
UnPaCKIng tHE WaSHEr (cont.)
7.Insert shipping bolt hole covers into shipping bolt holes.
nOtES:
•Failure to remove the shipping braces can cause the washer to become severely unbalanced.
•Save all bolts for future use.
•If you must transport the washer at a later date, you must reinstall the shipping support hardware to prevent shipping damage. Keep the hardware in the plastic bag provided.
15
