7
8
| GEAppliances.com |
Signal |
|
When the light is “on,” the washer will | To turn the signal off, press the SIGNAL |
beep at the end of the cycle and every | button and the light will go off. |
time you press a button on the control |
|
panel. |
|
Extra Rinse |
|
Use an extra rinse when additional |
|
rinsing is desired to remove excess dirt |
|
and detergent from soiled loads. |
|
Safety Instructions Operating
9
Delay Start
Use to delay the start of your washer.
1.Choose your wash cycle and any options.
2.Press DELAY START button. You can change the delay time in
3.Press the START/PAUSE button to start the countdown.
The countdown time will be shown in the
ESTIMATED TIME REMAINING display.
NOTES:
n If the door is opened while the washer is in DELAY, the countdown time will continue to count down the delay time. If the door is not closed and the countdown time expires, the cycle will not start until the door is closed and the START/PAUSE button is pressed.
n You can delay the start of a washer cycle up to 18 hours.
The light on the button will light up when
DELAY START is on.
Instructions
Installation Instructions
10
Lock
You can lock the controls to prevent any selections from being made. Or you can lock or unlock the controls after you have started a cycle.
Children cannot accidentally start the washer by touching pads with this option selected.
To lock the washer, press and hold the TEMP and SPIN buttons together for 3 seconds.
To unlock the washer controls, press and hold the TEMP and SPIN buttons together for 3 seconds. A sound is made to indicate the lock/unlock status.
The control lock icon on the display will light up when it is on.
NOTE: The POWER button can still be used when the machine is locked.
Troubleshooting Tips
11
My Cycle
To save a favorite cycle, set the desired settings for wash cycle, soil level, spin speed and wash temp settings and hold down the MY CYCLE button for
3 seconds. A beep will sound to indicate the cycle has been saved.
To use your custom cycle, press
the MY CYCLE button before washing a load.
To change the saved cycle, set
the desired settings and hold down the MY CYCLE button for 3 seconds.
NOTE: When using MY CYCLE, wash options cannot be modified after the cycle has been started.
NOTE: If you change wash options
with MY CYCLE before starting the cycle, the MY CYCLE light will turn off and you will be returned to the base cycle.
7
Consumer Support
