GE ZBD6600, ZBD6400, ZBD6900, ZBD6500, ZBD6700, ZBD7100, ZBD7000 owner manual Cycles

Clean

Sensor

Tone Silencing (on some models)

Auto

Memory

Child Lockout Mode (on some models)

Cycle Chart

Detergent Usage Guide (Powder or Liquid)

16

Features — ZBD6400, ZBD6500, ZBD6700, ZBD6900, ZBD7000 & ZBD7100

Dishwasher

The Clean Sensor monitors the circulating water during the cycles and sets the water temperature and cycle length to match soil levels. Cycle length is automatically increased to handle increasing levels of soil.

You can prevent the beep from sounding when selecting control settings.

1.Press the START/CANCEL and NORMAL WASH buttons together prior to selecting settings.

2.To have sound again, simply press the START/CANCEL and NORMAL WASH buttons together again.

Your dishwasher has the ability to remember what options you like with NORMAL WASH and POTS & PANS wash cycle. This means that if you select NORMAL WASH your dishwasher will automatically select the options that you selected last time you washed with the NORMAL WASH cycle. You can change the options that have been remembered with a particular wash cycle if you desire.

To reduce the possibility of children starting the dishwasher when unattended, a child lockout feature can be enabled. Once enabled, each button must be pressed and held for two seconds until you hear a BEEP, before the dishwasher will respond. While in this mode the SENSING and CLEAN light will illuminate while the button is pressed.

This feature can be enabled by pressing both the START/CANCEL and POTS & PANS buttons together and holding both for two seconds. You will hear three BEEPS when the child lockout is enabled.

The child lockout can be cancelled by pressing the START/CANCEL and POTS & PANS together and holding both pressed for two seconds until a single BEEP is heard.

NOTE: Child lockout overrides tone silencing.

						APPROXIMATE CYCLE TIME*
	TEMPERATURE (°F)					With 120°F Water
					WATER USAGE	(excluding drying time)
					(Gallons)
CYCLES	Normal	High	Sani			Normal	High	Sani
POTS AND PANS	145	155	171		6.2–7.4	80	85	102
NORMAL	131	135	160		5.0–11.2	72	75	89
CHINA CRYSTAL	125	—	—	5.0		31	—	—
RINSE ONLY	—	—	—	1.2		11	—	—
SPEED WASH	115–125	—	—	3.8		22	—	—
SANI WASH	160	—	—	6.2		89	—	—
(on some models)

*Cycle length will vary based on water temperature option and soil level present.

		SOFT WATER			MEDIUM WATER		HARD WATER
		0–3 grains			3–7 grains		7–12 grains*
CYCLES	Main Cup		Auxiliary Cup	Main Cup		Auxiliary Cup	Main Cup	Auxiliary Cup
POTS & PANS		Full	None		Full	Full	Full	Full
NORMAL WASH	1⁄2	Full	None		Full	None	Full	Full
CHINA CRYSTAL	1⁄2	Full	None		Full	None	Full	Full
SPEED WASH	1⁄2	Full	None		Full	None	Full	Full
RINSE & HOLD		Use no detergent			Use no detergent		Use no detergent
*12 grains and up is extremely hard water. A water softener					NOTE: The above chart is a general guide. Detergent
is recommended. Without it, lime can build up in the					amounts should be adjusted depending on the amount
water valve. The water valve may stick and flooding could					and type of soil until satisfactory results are achieved.
occur.