GE ZBD6700 Questions? Use this problem solver, Problem, Possible Cause, What To Do, not clean

Questions?

Use this problem solver

PROBLEM	POSSIBLE CAUSE	WHAT TO DO
Suds in the tub	Correct detergent	•	Use only automatic dishwasher detergents
	was not used		to avoid sudsing.
		•	To remove suds from the tub, open the
			dishwasher and let suds evaporate. Add
			1 gallon of cold water to the tub.
		For 7000 series models:
		•	Pump out water by pressing the
			NORMAL WASH button; then press the
			START/CANCEL button.
		•	Close the door until it locks into place.
		•	Wait for one minute; then carefully
			open the door and hold down the
			START/CANCEL button for three seconds.
		For all other models:
		•	Pump out water by closing the door until it
			locks into place.
		•	Press the NORMAL WASH button; then
			press the START/CANCEL button.
		•	Wait for one minute; then press and hold
			down the START/CANCEL button for
			three seconds. Repeat if necessary.
	Too much rinse agent used •		Remove any spilled rinse aid.
		•	Reduce rinse aid setting.
		•	For soft water, rinse aid may be unnecessary.
Dishes and flatware	Improper rack loading	•	Make sure large dishware does not block
not clean			the detergent dispenser or the wash arm.
		•	Assure silverware is not blocking spray
			arm.
	Filter or spray arms dirty	•	Clean filters and spray arms according to
			instructions on page 22.
	Inlet water temperature is	•	Run tap until water is hot, prior to starting
	below 120°F		dishwasher cycle.
		•	Raise the water heater temperature to
			120°F.
		•	Depending on model, use WATER TEMP
			HIGH or WATER TEMP SANI option if
			suitable for dish load.
	Air gap is clogged	•	Clean the air gap.
	Water pressure is	•	Turn on a faucet. Is water coming out
	temporarily low		more slowly than usual? If so, wait until
			pressure is normal before using your
			dishwasher.

25