Water Fill Level
For best performance, check the water fill level of your Chef’s Washer.
Once the Chef’s Washer is fully connected, run it through a complete RINSE ONLY (on some models) cycle to ensure it is emptying and filling correctly. For low water pressure situations, run the RINSE ONLY (on some models) cycle 3 times. Halfway through the final RINSE ONLY (on some models) cycle, pause the Chef’s Washer and check the water level inside the Chef’s Washer. If the water level is not above the minimum water level (marked on the lower spray support tower), increase the fill level.
1.Ensure the Chef’s Washer is not running through a cycle. Depress the WATER TEMP button for ten seconds until the second buzzer sounds.
2.Press the START/CANCEL button to select fill time, as per chart (65 seconds is the factory setting).
3.To test time, press DELAY START. The Chef’s Washer will start filling. Listen for the Chef’s Washer to complete filling. Once filled, the fill level must be checked to ensure fill time is correct.
4.Once complete, press the WATER TEMP button to exit fill time mode.
Maximum level 
Minimum level
Continue to press the
START/CANCEL button until the desired indicator is illuminated.
Cycle Status |
|
Indicators | Fill time |
|
|
SENSING | 55 seconds |
WASHING | 60 seconds |
RINSING | 65 seconds |
DRYING | 75 seconds |
CLEAN | 85 seconds |
|
|
21
