GE Monogram ZBD6605 Control Settings Start a Wash Load, Control Panel/Operation ZBD7005 & ZBD7105

Control

Settings

Start a Wash Load

Control Panel/Operation – ZBD7005 & ZBD7105

Chef’s Washer

4.DELAY START–This option will allow you to delay the start time of any wash cycle except RINSE ONLY for up to 6 hours.

•Select the delay start time you want by pressing the DELAY START button. Multiple pressing will alternate the delay time between 2, 4 or 6 hours and OFF.

To start the Chef’s Washer, open the Chef’s Washer door so that the top-of-door controls are visible. The last used cycle will be displayed. To begin this cycle, press the START button. To select a different cycle, press the desired Cycle Selection and Option buttons, and then press the START button. After the door is closed and latched, the selected cycle will begin.

To interrupt/pause a cycle, gently open the door just enough to turn off the wash motor. Do not fully open the door until the wash action ceases.

WARNING: Do not fully open door while the Chef’s Washer is in operation. Quickly opening the door while the Chef’s Washer is operating could result in serious scalding. Be careful when opening the door; the hot steam that escapes when the door

is opened may cause injuries. Stand back as you open the door and allow the steam to escape.

AVERTISSEMENT : N’ouvrez pas complètement la porte lorsque la laveuse fonctionne. Une ouverture rapide de la porte lorsque l’appareil est en fonctionnement peut entraîner de sérieuses brûlures. Faites attention lorsque vous ouvrez la porte; la vapeur brûlante qui s’échappe lors de l’ouverture de la porte peut causer des blessures. Tenez vous en arrière lorsque vous ouvrez la porte afin de permettre à la vapeur de s’échapper.

To restart the wash process, close the door until it locks in place. There may be a time delay of up to a few minutes because the temperature inside the Chef’s Washer needs to stabilize before it restarts the wash cycle.

To cancel the cycle after it has started, press and hold the START/CANCEL button for 3 seconds. The Chef’s Washer will start to drain and the cycle indicator lights will flash. At this point a new wash cycle can be selected. If a new cycle is not selected, all the Cycle Indicator lights will go out after the Chef’s Washer drains completely. If you have selected a new wash cycle, remember to add more detergent to the detergent compartment if required.

13