Installation
Micr owav e Oven
JX827WN installation
Screw A |
•Install rear duct by inserting into bottom flange between the oven and back of base pan.
–The rear duct should be as far to the left as possible, between the base pan back flange and the partition on the right side.
•Locate and use screws A.
•Drive one screw through the rear duct into the partition in the base pan.
•Drive one screw into the rear duct side flange near the lamp cover.
•Drive three screws through the base pan into the rear duct bottom.
•Replace the screw removed from the top left to complete the rear duct.
•The kit should be completely sealed to the micro- wave oven in the back.
Caution: Do not pinch power cord.
Screw C |
•Plug the power cord into the wall receptacle.
•Gently slide the microwave oven assembly into the cabinet opening, keeping it centered.
•Push to the back, allowing tongues of rear brackets to slide through rear slots.
•Check to be sure oven is centered.
•Locate and use screws C.
•Drive two screws through the base pan front flange through the holes drilled initially.
10
