Installation
Microwave Oven
ZEM200WV
Tools and materials required:
•Tape
•Line cord holder (supplied) •Two brackets (supplied)
1513/32" |
Template 1 |
Template 2 |
•Carefully remove the four plastic plug buttons from oven top and the two screws at top rear flange of case.
•Remove the two top case screws on the back of oven. Retain screws.
•Secure the two rear brackets to back of the oven, left and right, using screws removed earlier.
–Make sure brackets are level and flush with top surface of case.
•Cut Template 1 along dotted lines.
Mounting holes for the oven should be drilled from the inside, if cabinet shelves are removable to allow enough space. Holes may be drilled from bottom, if necessary.
To drill from inside
•Place Template 2 inside the cabinet:
–If cabinet is less than 12" deep, cut off front edge of template to fit, using template cut lines as a guide.
–If cabinet has a recessed shelf, measure the thickness of the front rail and cut that amount off the front edge of template. This will allow template 2 to lie flat.
12