Installation
Micr owav e Oven
JX827WN installation
Tools and materials required:
•Accessory kit JX827WN for
•2 Phillips head screwdrivers (#1 & #2)
•Drill and 3/32" drill bit •Centerpunch or nail •Pencil and ruler
JX827WN Parts List
1.Base Pan
2.Rear Duct
3.Side Covers (2)
4.Top Trim
5.Bottom Trim
6.Side Trims
7.Rear Holddown Brackets Screws A (9 required 1 extra)
B (4 required 1 extra) C (10 required 2 extra) D (4 required 1 extra) E (4 required 1 extra)
|
| 4 |
|
|
| 7 |
|
|
|
|
|
| |
|
| 5 |
|
|
| D |
|
|
| 6 | A |
| |
|
|
|
| B | ||
| 1 |
|
|
|
| E |
|
|
| 2 |
|
| C |
|
|
|
|
|
| |
|
| Parts Inventory |
|
|
| |
|
|
|
|
| 3 | 3 |
|
|
|
|
|
| |
Screw A | Screw B | Screw C | Screw D | Screw E |
|
|
Screw B |
Screw C |
•Set the base pan into cabinet cutout and center left and right. Front flange should be pushed back against front wall, flush with opening.
•Mark the opening precisely at the center line.
•Drill two 3/32" diameter holes into the base supporting structure, using the two holes in the base pan front flange as a guide.
•Drive two screws into the base pan front flange to temporarily hold in place.
•Slide two rear holddown brackets into slots in the rear of base pan. Tongues should be sticking into the base pan and centered in the slot.
•Mark and drill four 3/32" holes.
•Mount both brackets.
•Remove two screws in the base pan front flange and slide the base pan straight out.
8
