Installation
Microwave Oven
To drill from inside (continued)
–Position remaining piece of Template 2 inside cabinet and align hole center line with arrows on Template 1.
–Cut excess paper from center of Template 2 so it will lie flat.
–Distance from right hole center to left hole center should measure distance indicated on template.
–Tape remaining portion of Template 2 in place.
•With template secured in place, check again that hole center lines on Template 2 are straight, and that distance from right to left hole center measures distance shown on template.
To drill from bottom
•Position Template 2 flat against underside of cabinet:
–If cabinet is less than 12" deep, cut that amount off front edge of template.
–If cabinet has a front rail, cut front edge of template to fit; place cut edge against back of front rail.
–Cut template to fit around corner brackets or glue blocks underneath cabinet.
If cabinet has a partition
If cabinet has partition:
–Cut Template 2 into two pieces to fit on either side of partition.
–Align front edge of one template piece with front edge of cabinet or back of front rail; tape in place.
–Tape Template 1 to rear of cabinet, aligning arrow with hole center line on Template 2.
–Position remaining piece of Template 2 under cabinet and align hole center line with arrows on Template 1.
–Cut excess paper from center of Template 2 so it will lie flat.
–Distance from right hole center to left hole center should measure distance indicated on template.
–Tape remaining portion of Template 2 in place.
13 |
