Care and Cleaning
Professional Outdoor Grills & Cooktops
Main grill burners
Ensure the gas supply is off, the knobs are in the OFF position and all surfaces are cool before removing a burner.
To remove the grill burner, first remove the grill grate. Then, lift out the heat diffuser. Remove the anchor bolt and pull the burner up and slightly to the rear of the unit . The burner head comes off the orifice at the front . Angle the burner sideways and remove.
Clean the exterior of the burner(s) with a wire brush. Be sure burner ports are clear and free from debris. Clear any clogged ports with a straightened paper clip. Never use a wooden toothpick as it may break off and clog the port . Never enlarge the burner ports. Shake out any debris through the air shutter. Use a flashlight to inspect the burner inlet to ensure it is not blocked. If obstructions can be seen, use a metal wire coat hanger that has been straightened out or a pipe cleaner to clear them.
To replace the burner, angle it into the grill box and position its front corner under the igniter while sliding the burner head through the grill orifice hole. Center the burner head onto
the orifice while being careful not to bend the igniter electrodes. It is extremely important to center the burner on the orifice properly.
Be careful not to upset the air shutters' original position (unless readjusting). Lower the rear burner bracket brace into the cutouts in the grill bracket brace. Reattach the anchor bolt to
the brace. Make sure all burners are level and seated in the grill box.
Replace the heat diffuser and the grill grate.
Light all of the burners and check for proper flame characteristics. Do not attempt to light the burners prior to replacing all grill parts. If adjustments are necessary, refer to
the Installation Instructions.
Anchor bolt 
Ports
Air shutter | Main burner |
Anchor bolt
Burner |
| |
bracket |
| |
brace |
| |
Burner | Grill | |
bracket | ||
| box | |
Spark | Grill | |
igniter | ||
orifice | ||
electrodes | ||
hole | ||
| ||
| Burner | |
| head |
Orifices
With the burner removed, shine a flashlight through the hole in the grill box to inspect the orifice to ensure there is no blockage.
Use a needle to clear any debris. Be extremely careful not to enlarge the hole or break off the needle.
24
