GE Monogram ZGG420LBPSS owner manual Battery replacement, To access and remove the battery

Care and Cleaning

Professional Outdoor Grills & Cooktops

Battery replacement

The grill has a battery back-up which provides power to the grill ignition system, allowing it to operate when not connected to an AC outlet or during an electrical power outage.

For built-in grill models, the battery location varies depending on where the installer located it during installation.

For free-standing models, the battery is located on the back side of the grill behind the lower access panel.

To access and remove the battery:

1.On free-standing models, remove the back panel access screws. (On built-in models, locate and access the battery from the front of the grill.)

4.Use a coin or small screwdriver to open the battery drawer by pressing up on its access slot .

Access slot in battery drawer

5.Replace with a new 9-volt battery being careful to insert it in the battery drawer by the keyed terminal size.

Retaining flange

Lower back panel

2.Remove the back panel by lowering it from under the upper retaining flange.

Retaining flange

Battery location

Keyed terminal size

To replace:

1.Close the battery drawer firmly into the battery/fuse-mounting assembly.

2.Make sure the wiring terminal cover is over the wiring terminal connections.

Wiring terminal cover

NOTE: You may find it more convenient to access the battery and fuse by removing the roller-supported drawers and reaching to the rear wall support bracket . You may also extend the slide-supported tall drawer to reach the rear of the grill. To remove the drawers, pull forward, tilt up and pull out on the drawer.

3.Remove the battery/fuse-mounting assembly from the lower right inside wall of the grill by firmly grasping it and pulling it straight up.

3.Slide the battery/fuse-mounting assembly down over its retaining bracket on the inside back wall of the grill.

4.Replace the lower back panel by sliding it under the upper retaining flange and securing all screws removed earlier.

Battery/fuse- mounting assembly

28