RS-232 SERIAL CONTROL
#RSTIP Command
The #RSTIP command sets the current IP configuration to factory (default) settings.
Syntax:
#RSTIP
Parameters:
None
Notes:
A reboot is required after using this command.
#SIPADD Command
The #SIPADD command specifies a new IP address.
Syntax:
#SIPADD param1 param2 param3 param4
Parameters: |
|
|
param1 | IP address | [0 - 255] |
param2 | IP address | [0 - 255] |
param3 | IP address | [0 - 255] |
param4 | IP address | [0 - 255] |
Notes:
A reboot is required after using this command.
25
