Gefen EXT-COMPAUD-CAT5-444 Adjusting the 4X4 Component Matrix Over CAT-5 Receiver, Brightness

ADJUSTING THE 4X4 COMPONENT MATRIX OVER CAT-5 RECEIVER

Each 4x4 Component Matrix Over CAT-5 Receiver has two trim pots used to adjust the brightness and focus of the video output. These adjustment trim pots are located on the front panel of each unit. Please use the guidelines below for adjusting both trim pots.

Brightness

If the image appears too dim or too bright, adjust the brightness trim pot.

1.Insert a small flathead adjustment tool into the trim pot.

2.Turn the trim pot in a clockwise fashion until the trim pot stops turning. Do not force the trim pot beyond this point as it may break and will render the trim pot useless.

3.Turn the trim pot in millimeter increments in a counter-clockwise fashion until the desired brightness is reached.

4.Remove the trim pot adjustment tool.

Focus

If the image is out of focus, or the colors are smeared, adjust the focus trim pot.

1.Insert a small flathead adjustment tool into the trim pot.

2.Turn the trim pot in a clockwise fashion until the trim pot stops turning. Do not force the trim pot beyond this point as it may break and will render the trim pot useless.

3.Turn the trim pot in millimeter increments in a counter-clockwise fashion until the desired focus is reached.

4.Remove the trim pot adjustment tool.

14