Genie 3042 manual Overview Remotes and Options, Hold, Press both, Simultaneously on

Three Button

Remote

5 OVERVIEW - REMOTES AND OPTIONS

WARNING

A moving door can cause serious injury or death.

1.Keep people clear of opening while door is moving.

2.Do NOT allow children to play with opener, including wall console, remote, or wireless keypad.

3.During programming, the door opener could begin to run, so keep people and objects away from the moving door and its parts. To keep the door from moving, close the door and disconnect it from the rail carriage by pulling the Emergency Release Handle. See page 19 for Release Handle operation.

LOST OR STOLEN REMOTE - CLEARING MEMORY

Clearing remotes from powerhead memory will clear ALL programmed remotes and wireless keypad.

NOTE: Follow the PROGRAM REMOTE TO POWERHEAD steps to re-enter remaining or new remotes. See page 9.

			PROGRAM	+
1. Press	PROGRAM	and hold		—
	SET			SET

until both lights come ON BLUE. Release button.

FIG. 5-1 Remote

See page 21 for battery changing instructions.

PROGRAM

3.Press SET again and long LED flashes

PURPLE.

2.Lights go out and Round BLUE light comes ON.

PROGRAM	+
	—
	SET

FCC and IC CERTIFIED

This device complies with FCC Part 15 and RSS

210 of Industry Canada. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which may be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:

•Re-orient or relocate the receiver antenna.

•Increase the separation between the opener and receiver.

•Connect the opener into an outlet on a circuit different from that to which the receiver is connected.

•Consult your local dealer.

4.	Press both and	PROGRAM	+
	simultaneously on the		—

powerhead and hold until both LEDs flash BLUE.

•Verify memory is cleared. Press a remote button that was previously programmed to the powerhead. Remote will not activate door opener.

•Garage door opener will operate normally using wall console.

•Program remaining or new remotes as shown on page 9. Your door opener will no longer recognize any signal received from the missing remote, or any other which has not been reprogrammed to the powerhead.

©2011 The Genie Company 3/2011 15