12.POWER-CORD PROTECTION - Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords of plugs, convenience receptacles, and the point where they exit from the unit.

13.OUTDOOR ANTENNA GROUNDING - If an outside antenna or cable system is connected to the video unit, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mast and supporting structure, ground- ing of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to ground- ing electrodes, and requirements for the grounding electrode. See figure below.

14.LIGHTNING - For added protection of this video unit during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the video unit due to lightning and power line surges.

15.POWER LINES - An outside antenna system should not be located in the vicinity of over- head power lines or other electric light or power circuits, where it can fall into such power lines or circuits. When installing an outside antenna system extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

16.OVERLOADING - Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.

17.OBJECTS AND LIQUIDS - Never push objects of any kind into this video unit through open- ings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquids of any kind onto the unit. Should spillage occur, unplug unit and have it checked by a tech- nician before use.

18.SERVICING - Do not attempt to service this video unit yourself as opening or removing covers may expose you to a dangerous voltage or other hazards. Refer all servicing to quali- fied service personnel.

19.DAMAGE REQUIRING SERVICE - Unplug this video unit from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power supply cord or plug is damaged.

b.If any liquid has been spilled onto or objects have fallen into the video unit.

c.If the video unit has been exposed to rain or water.

d.If the video unit does not operate normally by following the operating instructions. Adjust only those controls that are covered

by the operating instructions. Improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the video unit to its normal operation.

e.If the video unit has been dropped or the cabinet has been damaged.

f.When the video unit exhibits a distinct change in performance—this indicates a need for service.

20.REPLACEMENT PARTS - When replacement parts are required, be sure the service techni- cian has used replacement parts specified by the manufacturer or those having the same characteristics as the original part. Unautho- rized substitutions may result in fire, electric shock or other hazards.

21.SAFETY CHECK - Upon completion of any service or repairs to this video unit ask the service technician to perform safety checks to determine that the video unit is in safe operating order.

22.HEAT - This video unit should be situated away from heat sources such as radiators, stoves, or other products (including amplifiers) that produce heat.

iiDUAL-DECK VCR USER'S GUIDE

Page 4
Image 4
Go-Video DDV9000 manual Ii DUAL-DECK VCR Users Guide