Gold's Gym GGBE24320 manual Locknuts yet

3. Attach the Bench Frame (2) to the Cross Frame	3
(1) with two M10 x 68mm Bolt (33) and two M10
		33
Nylon Locknuts (32). Do not tighten the
Locknuts yet.
		1
	2	32
4. Press a 50mm x 100mm Inner Cap (17) into the	4
top of an Upright (5).
		17
Orient the Upright (5) with a decal applied to it, so
that the adjustment holes are on the indicated		Adjustment
side. Attach the Upright to the Cross Frame (1)
		Holes
and a Large Support Plate (12) with two M10 x		5
68mm Bolts (33) and two M10 Nylon Locknuts
(32).	Decal on
	this Upright
Repeat this step with the other Upright (5).
Tighten the M10 Nylon Locknuts (32) used in
steps 1–4.
		1
		12
	32
		33
5. Press two Weight Rest Bushings (16) into the top	5
and bottom of a Weight Rest (6).
Pull the Weight Rest Knob (28) out as far as it will	16
go and slide the Weight Rest (6) onto an Upright		6
(5). Engage the Knob into an adjustment hole in
the Upright.
Repeat this step with the other Weight Rest		28
(6). Set both Weight Rests at the same height.
		16
		5

6