35.Locate the Low Cable (59). Lay the Cable inside the bracket on the Center Base (24) so that the ball is on the side shown. Attach a 4 1/2” Pulley
(35)inside the bracket with an M10 x 45mm Bolt
(76)and an M10 Nylon Locknut (77).
36.Route the Low Cable (59) through the Center Upright (3) and under the bar in the bracket on the Center Base (24). Wrap the Cable around an 88mm Pulley (36). Attach the Pulley to the rear hole in the bracket on the Center Base with an M10 x 45mm Bolt (76) and an M10 Nylon Locknut (77).
37.Wrap the Low Cable (59) around a 4 1/2” Pulley
(35).Attach the Pulley and a Large Cable Trap
(55)to the bottom set of holes in the pair of Pulley Plates (31) with an M10 x 45mm Bolt (76) and an M10 Nylon Locknut (77).
38.Wrap the Low Cable (59) around an 88mm Pulley (36). Attach the Pulley to the front hole in the bracket on the Center Base (24) with an M10 x 45mm Bolt (76) and an M10 Nylon Locknut (77).
35 |
|
35 |
|
77 |
|
Ball |
|
59 |
|
24 |
|
Bracket | 76 |
36 |
|
| 59 |
77 | 36 |
| |
Bar | Bracket |
| |
3 | 76 |
| 24 |
37 |
|
| 31 |
77 | 76 |
| |
55 | 35 |
| |
| 59 |
38 |
|
36 |
|
59 |
|
77 |
|
| Bracket |
| 24 |
| 76 |
14
