ADJUSTMENTS
This section explains how to adjust the weight bench. The first time you perform an exercise that uses the safety spotter, adjust the bench to the position that is best for you. Note the position of the weight rest and safety spot- ter on the BENCH ADJUSTMENT CHART, on page 20 of this manual. When preparing to perform the exercise again, refer back to the chart for a quick reference to your personal settings.
See the EXERCISE GUIDELINES on page 21 for important information about how to get the most benefit from your exercise program. Also, refer to the accompanying exercise guide to see the correct form for each exercise.
Make sure all parts are properly tightened each time the weight bench is used. Replace any worn parts immediate- ly. The weight bench can be cleaned with a damp cloth and a mild,
ADJUSTING THE BACKREST
The Backrest (38) can be used in a decline position, a level position, or any of five incline positions. To adjust the Backrest, turn the Knob (30) counterclock- wise until loose. Pull the Knob out as far as it will go and slide the Sliding Seat Frame (15) to the desired position. Engage the Knob into an adjustment hole in the Bench Frame (14). Turn the Knob clockwise until tight.
ADJUSTING THE WEIGHT RESTS AND SAFETY SPOTTER
Before performing an exercise that uses a barbell, adjust the Weight Rests (11, 12) and Safety Spotter
(25)to the height that is best suited for that exercise. The Weight Rests should be at a comfortable height for lifting and replacing the barbell. Moving the Safety Spotter (10) will change the distance that the barbell can move. First, attach the barbell to the high cable (see ATTACHING A BARBELL TO THE CABLES, on page 17). Then, set the Safety Spotter to the position that will stop the barbell at the lowest point that you want it to go during the exercise.
To adjust a Weight Rest (11, 12) turn the Knob (30) counterclockwise until loose. Pull the Knob out as far as it will go and move the Weight Rest to the desired height. Engage the Knob into an adjustment hole in the Upright (1, 2) and turn it clockwise until tight.
The Safety Spotter (10) can be adjusted in the same manner.
WARNING: Always adjust both Weight Rests (11, 12) to the same height before exercising.
| 38 |
14 |
|
| 15 |
Adjustment | 30 |
| |
Holes |
|
| 10 |
30 |
|
12 |
|
2 |
|
| 11 |
| 1 |
16
