Lower the treadmill (see HOW TO LOWER THE TREADMILL FOR USE on page 21). Remove the three #8 x 3/4" Screws (6). Carefully slide the Motor Hood (57) off.
57 | 6 |
| 6 |
Locate the Reed Switch (95) and the Magnet (44) on the left side of the Pulley (43). Turn the Pulley until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If necessary, loosen the #8 x 3/4" Truss Head Screw (19), move the Reed Switch slightly, and then re- tighten the Screw. Reattach the Motor Hood (not shown) with the five #8 x 3/4" Screws (not shown) and run the treadmill for a few minutes to check for a correct speed reading.
Front | 43 | 1/8 in. |
View | ||
| 44 | 19 |
|
| 95 |
SYMPTOM: The incline of the treadmill does not change correctly
a.With the key in the console, press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the maximum incline level and then return to the mini- mum level. This will recalibrate the incline system.
SYMPTOM: The walking belt slows when walked on
a.Use only a
14.
b.If the walking belt is overtightened, treadmill per- formance may decrease and the walking belt may become damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.
b |
Idler Roller Screws |
c.Your treadmill features a walking belt coated with
d.If the walking belt still slows when walked on, see the front cover of this manual.
23
