Gold's Gym GGCTL59611.0 manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.

•The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

•To identify small parts, see page 6.

•Assembly requires the following tools:

the included hex keys one adjustable wrench one Phillips screwdriver scissors needlenose pliers

To avoid damaging parts, do not use power tools.

1.Make sure that the power cord is unplugged.

Locate the Upright Wire (70) bundled around the front of the Base (80) beneath the Belly Pan (68). Cut the plastic tie securing the Upright Wire.

Route the Upright Wire into the Base and out of the indicated hole.

Press a Base Cap (77) into each side of the Base (80).

See the inset drawing. Cut the plastic tie near the Upright Wire (70). Be careful not to damage the Upright Wire.

1
80	68
		70
	Cut
	Hole	Tie
	77	Cut
		70

7