Gold's Gym GGEL66008.0 manual Assembly, Wrench A rubber mallet

ASSEMBLY

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480. Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

In addition to the included tool(s), assembly requires a Phillips screwdriver			, an adjustable
wrench	, and a rubber mallet	.

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe- ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.

M8 Split	M10 Spring	Wave Washer	Large Wave
Washer (97)–10	Washer (99)–4	(80)–2	Washer (89)–2
M10 Washer		M8 x 22mm	M8 Locknut
(95)–4		Washer (31)–2	(94)–2
M4 x 16mm	M4 x 25mm Screw	M8 x 12mm Patch	M8 x 19mm Patch
Screw (78)–4	(114)–2	Screw (84)–6	Screw (86)–6
M8 x 40mm Patch		M8 x 58mm Shoulder	M10 x 20mm Patch
Screw (90)–6		Bolt (104)–2	Screw (68)–4
	M10 x 80mm Patch Screw (93)–4
		5