Gold's Gym GGEL66008.0 manual Maintenance and Troubleshooting, Console Troubleshooting

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console displays become dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 10 on page 10 for replacement instructions. If the handgrip pulse sensor does not function properly, see step 5 on page 18.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the
reed switch should be adjusted. First, remove all of the
screws from both shields; there are three sizes of
screws in the shields—note which size of screw
you remove from each hole. Then, gently pry the
shields away from the frame.
Next, locate the
Reed Switch (50).	50		100 62
Turn the Pulley		78
Disc (62) until the
Magnet (100) is
aligned with the
Reed Switch.
Loosen, but do
not remove, the
indicated M4 x
16mm Screw
(78). Slide the
Reed Switch slightly closer to or away from the
Magnet, and then retighten the Screw. Rock the Pulley
Disc forward and backward just enough that the
Magnet passes the Reed Switch repeatedly. Adjust the
Screw until the console displays correct feedback.
When the Reed Switch is correctly adjusted, reattach
the shields. Note: If you have questions as to which
screw should be in which hole, see EXPLODED
DRAWING B on page 27 and the PART LIST on page
24.

HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance of the pedals is at the high-
est setting, the Belt (74) may need to be adjusted.
First, remove all the screws from both shields; there
are three sizes of screws in the shields—note
which size of screw you remove from each hole.
Then, gently pry the shields away from the frame.
Next, turn the Belt
Adjustment Screw
(115) until the	74
Belt (74) is tight.
Then, reattach
the shields. Note:
If you have ques-
tions as to which
screw should be	115
in which hole, see
EXPLODED
DRAWING B on
page 27 and the PART LIST on page 24.

22