71

GDR10A

DiggitalTVTVreceiverReceiver

71

 

ADR10 Set Top Box

 

Electrical safety

Read the electrical-safety pages in this guide carefully before you connect the receiver to the mains supply.

Make sure your electricity supply is the same voltage as the voltage printed on the label on the bottom of the main unit of your receiver.

The receiver needs a 230-volt (V) 50-hertz (Hz) mains supply. Do not use any other supply. The receiver comes with a moulded plug. If the plug breaks, you cannot reuse the plug. If you need to change the fuse in a moulded plug you must refit the fuse cover. If you lose or damage the fuse cover, you must not use the plug until you have a replacement plug cover or plug.

If you have to change the plug because it is not suitable for your socket, or it is damaged, you should remove it and fit the right plug using the wiring diagram shown on the next page. You must throw the plug away safely. You could get an electric shock if you use it again.

The colours of the wires in the receiver’s power lead may not match the coloured markings in your plug, so you should follow these instructions.

•You must connect the blue wire to the terminal marked with the letter ‘N’ or coloured black.

•You must connect the brown wire to the terminal marked with the letter ‘L’ or coloured red.

•You should not connect anything to the earth terminal of the plug marked with the letter ‘E’ or coloured green.