GoVideo DDV3120 manual T D O O R a N T E N N a O U N D I N G

O U T D O O R A N T E N N A

G R O U N D I N G

If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70,

provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See figure above.

L I G H T N I N G

For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power lines surges.

P O W E R L I N E S

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

O V E R L O A D I N G

Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.

O B J E C T A N D L I Q U I D E N T R Y

Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could

result in a fire or electric shock. Never spill liquid of any kind on the product.

S E R V I C I N G

Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

D A M A G E R E Q U I R I N G S E R V I C E

Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

aWhen the power-supply cord or plug is damaged,

bIf liquid has been spilled, or objects have fallen into the product,

cIf the product has been exposed to rain or water,

dIf the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation,

eIf the product has been dropped or damaged in any way, and

fWhen the product exhibits a distinct change in performance - this indicates a need for service.

R E P L A C E M E N T PA R T S

When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

S A F E T Y C H E C K

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

W A L L O R C E I L I N G M O U N T I N G

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

H E AT

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

iv

Dual-Deck VCR User’s Guide