12
Connections (Continued)
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your existing equipment.

RF coaxial connection

Connect the RF.OUTjack on the DVD+VCR to the
antenna in jack on the TV using the supplied 75-ohm
Coaxial Cable (R).
ote
If you use this connection, tune the TV to the
DVD+VCR’s RF output channel (CH 3 or 4).
How to set the DVD+VCR’s RF output channel
1.Set the TV to the VCR channel (3 or 4) depending
upon the selected channel.
2.When the DVD+VCR is turned off,
press and hold
CH (V/v) on the front panel for about five seconds.
It will turn itself on and “RF03” or “RF04” appears in the dis-
play window.
3.
Press CH (V/v) on the front panel or CH (v/V)on the
remote control to change the RF output channel (CH
03 or CH 04).
4.
Turn off the DVD+VCR.

Audio/Video connection

11
Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using the
supplied video cable (V).
22
Connect the Left and Right DVD/VCRAUDIO OUT
jacks on the DVD+VCR to the audio left/right in
jacks on the TV (A1) using the supplied audio
cables.
ote
If you use this connection, set the TV’s source selector
to VIDEO.
Optional, Preferred TV Connections
ote
You can ONLYwatch and listen to DVD playback
through the connections shown below.

S-Video connection

11
Connect the S-VIDEO OUT jack on the DVD+VCR
to the S-Video in jack on the TV using an optional
S-Video cable (S).
22
Connect the Left and Right AUDIO OUTjacks of
the DVD+VCR to the audio left/right in jacks on the
TV using the supplied audio cables (A2).

Component Video / Progressive Scan connection

zzIf your television is a high-definition or “digital ready”
television, you may take advantage of the
DVD+VCR’s progressive scan output for the highest
video resolution possible.
zzIf your TV does not accept the Progressive Scan for-
mat, the picture will appear scrambled if you try
Progressive Scan on the DVD+VCR.
11
Connect the COMPONENT / PROGRESSIVE
SCAN VIDEO OUT jacks on the DVD+VCR to the
corresponding in jacks on the TV using an optional
YPb Pr cable (C).
22
Connect the Left and Right AUDIO OUTjacks of
the DVD+VCR to the audio left/right in jacks on the
TV (A2) using the supplied audio cables.
otes
zzSet Progressive Scan to “On” in the setup menu for
progressive scan signal, see page 18.
zzWhen you use Component Video signal, set
Progressive Scan to “Off” in the setup menu.
zzProgressive scan does not work with the analog video
connections (yellow VIDEO OUT jack).
L
R
AUDIO INPUT VIDEO
INPUT
ANTENNA
INPUT
Rear of TV
Rear of DVD+VCR
A1 VR
Y
Pb
Pr
COMPONENT VIDEO INPUT
L
R
AUDIO INPUT S-VIDEO
INPUT
Rear of TV
Rear of DVD+VCR
S
A2
C