Operation
Operation
Pressure Relief Procedure
WARNING
Follow Pressure Relief Procedure, page 13 when you stop spraying and before cleaning, checking, ser- vicing, or transporting equipment. Read warnings, page 3.
1.Turn off air and fluid supply.
2.Hold a metal part of the gun firmly to a grounded metal pail. Trigger the gun to relieve pressure.
1.To achieve the best results when applying fluid:
•Keep the gun perpendicular and 6 to 8 inches (150 to 200 mm) from the object being sprayed.
•Use smooth, parallel strokes across the surface to be sprayed with 50% overlap.
Incorrect
ti4843a
Correct
ti4836a
FIG. 11
Applying the Fluid
When using the HVLP spray gun, instead of a conven- tional airspray gun, you may need to use a slightly slower hand movement and make fewer passes with the gun to coat a part. This is due to the reduced spray velocity produced by lower HVLP air pressures, along with a larger fluid particle size because there is less air to blow off solvents than what is produced by conven- tional airspray. Take care to avoid runs or sags as you spray.
ti4842a
FIG. 12
310692D | 13 |
