Graco 312068M important safety instructions Installing Final Four Spacers, Assembling Manifold

Repair

CAUTION

In the following step, do not over torque.

36.Hold the left clevis stationary with a 1 in. open-end wrench to keep the cross-holes horizontal and torque the baffle jam nut against the hydraulic piston shaft to 15 ft-lb (20 N•m) using a torque wrench.

	1
	TI11288a
	2
1	Hold stationary.
2	Rotate to torque the baffle jam nut to 15 ft-lb (20 N•m)
	against the hydraulic piston shaft, which torques the left
	clevis.

37.Double check that the left clevis cross-holes are hor- izontal and the right clevis cross-holes are vertical.

TI11289a

Installing Final Four Spacers

38.Preventing the tie rod (115) from spinning with one hand, spin one spacer (113) onto one end until it

butts against the retainer plate (101). Repeat for opposite end of tie rod.

Assembling Manifold

39.Insert pipe plugs (127) into manifold (125).

40.Insert o-rings (128) into bottom holes of manifold.

41.With the port holes facing the manifold, attach the manifold to the port blocks using the four screws (126).

		126
		125			2
				127
			128		113
	1			TI11291a
1	Have the port holes facing the
	manifold.
2	On Model 247624, rotate manifold 180
	degrees about the vertical axis.

42.Hold one spacer with the 1/2 in. open-end wrench and the other with the 1/2 in. torque wrench and torque to 15 ft-lb (20 N•m).

This ensures that the manifold is aligned with the pump assembly.

43. Repeat with the final two spacers.

14 312068M