Dell R210 II owner manual IDRAC6 Express Card Optional, Installing an iDRAC6 Express Card

4If applicable, replace the cooling shroud. See "Installing the Cooling Shroud" on page 69.

5Close the system. See "Closing the System" on page 51.

6Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

iDRAC6 Express Card (Optional)

Installing an iDRAC6 Express Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 50.

3If installed, remove the expansion card from the expansion-card slot. See "Removing an Expansion Card" on page 61.

4Insert the tab on the Integrated Dell Remote Access Controller 6 (iDRAC6) Express card into the clip on the system board.

5Align the front edge of the card with the connector on the system board. See Figure 6-1for the location of the connector.

6Press the card down until it is fully seated. See Figure 3-14.

When the front of the card is fully seated, the plastic standoff tab snaps over the edge of the holder.

76

Installing System Components