Dell R210 II owner manual Installing a 3.5-Inch Hard Drive

Installing a 3.5-Inch Hard Drive

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 50.

3To install HDD1, remove the optical drive (if present) mounted above the hard-drive carrier. See "Removing an Optical Drive" on page 52.

4Install the hard drive into the carrier. See "Installing a 3.5-Inch Hard Drive Into a Hard-Drive Carrier" on page 60.

5Align the four slots under the hard-drive carrier with the four tabs on the chassis. Slide the hard-drive carrier toward the chassis wall till it snaps into place. See Figure 3-7.

If you replaced HDD1, reinstall the optical drive (if present) above the HDD1 bracket. See "Installing an Optical Drive" on page 54.

6Connect the power/data cable to the hard drive:

•If connecting to the integrated SATA controller (SATA hard drives only), connect the SATA data cable to the SATA connector on the system board. See Figure 6-1.

•If connecting to a SAS RAID controller card (SAS or SATA hard drives), connect the data cable to the connector on the card edge. For information on installing a SAS controller card, see "Installing an Expansion Card" on page 62.

7Close the system. See "Closing the System" on page 51.

8Reconnect the system to the electrical outlet and turn on the system and attached peripherals.

58

Installing System Components