CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components.

4Slightly lift up the front of the system board and maneuver the system board to the bottom of the chassis until it lays completely flat.

5Push the system board toward the back of the chassis until the board is in place.

6Tighten the ten screws that secure the system board to the chassis. See Figure 3-21.

7Transfer the processor and the heat sink to the new system board. See "Removing a Processor" on page 82 and "Installing a Processor" on page 86.

8Replace all the memory modules and memory blanks. See "Installing Memory Modules" on page 71.

9Connect the cables in the order listed below (see Figure 6-1for the locations of the connectors on the system board):

SATA interface cable, if applicable

Control panel interface cable

Optical drive power cable

Control panel USB interface cable

System board power cables

10Install the expansion card, if any. See "Installing an Expansion Card" on page 62.

11If applicable, reinstall the iDRAC6 Enterprise card. See "Installing an iDRAC6 Enterprise Card" on page 79.

12If applicable, reinstall the iDRAC6 Express card. See "Installing an iDRAC6 Express Card" on page 76.

13Replace the cooling shroud. See "Installing the Cooling Shroud" on page 69.

14Close the system. See "Closing the System" on page 51.

15Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

96

Installing System Components

Page 96
Image 96
Dell R210 II owner manual Installing System Components