Pinion Assembly/Clutch Armature/Clamp

Pinion Assembly/Clutch Armature Removal

If pinion assembly (29) is not removed from clutch hous- ing (19), do 1. through 3. Otherwise, start at 4.

1.Remove drive housing.

2.Disconnect clutch cable connectors from inside of pressure control.

a.Remove two screws (71) and swing down cover (130a).

b.Disconnect engine leads from board to engine.

c.Remove strain reliefs 130r and 123.

3.Remove four screws (36) and pinion assembly (29).

ti5480a

4.Place pinion assembly (29) on bench with rotor side up.

5.Remove four screws (28) and lock washers (24). Install two screws in threaded holes (E) in rotor. Alternately tighten screws until rotor comes off.

28 29

E E

6.Remove retaining ring (29b).

7.Turn pinion assembly over and tap pinion shaft (29a) out with plastic mallet.

29b

29a

29d

ti5482a

8.Use an impact wrench or wedge something between clutch armature (25) and clutch housing to hold engine shaft during removal.

9.Remove four screws (23) and lock washers (24).

10.Remove armature.

TIA

ti5481a

ti5987b

332919C