Wetting System
Wetting System
1. Fill hopper (G) with prepared textured material.
G
ti3905a
NOTICE
Do not mix material in hopper. Mixing material in hopper can damage hopper, result in an inconsistent mix and packout can occur.
2.Install tip (see Nozzle Selection Chart, page 13).
3.Open gun air valve (23) to relieve air pressure.
23
TI
NOTICE
Do not allow material to flow out of gun when air valve (23) is closed or material packout in needle can occur.
NOTE: If spraying a simulated acoustic and course 
aggregate material, disconnect hose at gun, prime pump and hose and circulate material back into hopper for 10 seconds. Turn off pump. Install gun and tip.
4.Inspect hose for kinks which could restrict fluid flow.
5.Trigger gun into a pail. When texture material appears at tip, move gun to hopper and circulate until material flows in a solid stream. See System Adjustment (page 14) for proper spray pattern and pump and gun adjustments.
ti4290a
WASTE
6.Adjust gun air pressure (U) and pump air pressure
(T) on sprayer to achieve desired result.
U
T
10 | 313384B |
