Graco Inc 308584, 3500WB, 222700 manual PRO 3500sc Gun Conversion, PRO 3500SC Gun Disassembly

PRO 3500sc Gun Conversion

NOTE: See page 48 to order the conversion kit, part no. 223114. The fluid hose and air hose are not in- cluded with this kit. See page 48 to order hoses. Use only the electrically conductive air supply hoses and waterborne fluid hoses specified in this manual.

PRO 3500SC Gun Disassembly

1.Remove the air fitting (D), exhaust tube clamp (F), and the exhaust tube (E). Keep these parts for reassembly.

2.Remove the fluid tube fitting (B) and fluid seal (A) from the gun. See Fig. 30.

3.Remove the gun fitting bracket (C) with the hose assembly.

4.Remove the air cap assembly (G, P, Z) and dis- card the retaining nut (G).

NOTE: Keep all the following parts for reassembly.

6.Unscrew and remove the electrode needle (J) with the electrode tool. Be careful not to damage the contact wire. If the fluid rod turns, hold the back end of the fluid rod by placing a screw driver blade into the slot on the shaft, near the trigger.

7.Loosen the trigger screws (L) far enough to re- move the trigger (M).

8.Remove the fluid packing rod assembly (K) with the 9 mm hex nut driver.

H

Z

P

G

L C D

Q

AM

5.Point the front end of the gun up and squeeze the trigger while removing the fluid nozzle/resistor stud assembly (H) with the nozzle wrench.

K

J

B

R E

NOTE: If the resistor stud remains in the gun when the fluid nozzle is removed, start the nozzle thread onto the stud and pull the stud out.

Fig. 30

F

05423A

Continued on the next page.

308584 43