WARNING
FIRE AND EXPLOSION HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and result in a fire or explosion.
DElectrostatic equipment must be used only by trained, qualified personnel who understand the requirements stated in this instruction manual.
DGround the equipment, personnel in or close to the spray area, the object being sprayed, and all other electrically conductive objects in the spray area. See Ground the System on page 14.
DTest the gun electrical resistance daily as instructed on page 28.
DProvide fresh air ventilation to avoid the buildup of toxic vapors. See Ventilate the Spray Booth on page 9.
DOnly use this equipment to spray
DOnly flush, purge, or clean the electrostatic, waterborne spray system with
DDo not flush the system with the gun electrostatics turned on.
DUse only
DExtinguish all open flames or pilot lights in the spray area.
DKeep the spray area free of debris, including solvent, rags, and gasoline.
DDo not store any flammable fluids in the spray area.
DDo not turn on or off any light switch in the spray area while operating or if fumes are present.
DDo not smoke in the spray area.
DDo not operate a gasoline engine in the spray area.
PRESSURIZED EQUIPMENT HAZARD
Spray from the gun, hose leaks, or ruptured components can splash fluid in the eyes or on the skin and cause a serious injury.
DDo not point the spray gun at anyone or any part of the body.
DDo not stop or deflect fluid leaks with your hand, body, glove, or rag.
DFollow the Pressure Relief Procedure on page 16 whenever you: are instructed to relieve the pressure; stop spraying; clean, check, or servicing the equipment; and install or clean the fluid nozzles.
DTighten all the fluid connections before operating the equipment.
DCheck the hoses, tubes and couplings daily. Replace worn, damaged, or loose parts immediately. Permanently coupled hoses cannot be repaired; replace the entire hose.
Warnings are continued on the next page.
4308584
