Grandstream Networks, Inc. GXP1400/1405 User Manual Page 33 of 36
Firmware version: 1.0.1.83 Last Updated: 08/2011
No Key Entry Timeout
Default is 4 seconds.
Use # as Dial Key
This parameter allows users to configure the “#” key as the “Send” (or “Dial”) key. If
set to “Yes”, the “#” key will immediately send the call.
In this case, this key is
essentially equivalent to the “(Re)Dial” key. If set to “No”, the “#” key is incl uded as
part of the dial string.
G723 Rate
Encoding rate for G723 codec. By default, 6.3kbps rate is set.
G726-32 Packing Mode
Select “ITU” or “IETF” for G726-32 packing mode.
ilbc Frame Size
ilbc packet frame size. Default is 20ms. For Asterisk PBX, 30ms might be re quired.
ilbc Payload Type
Payload type for Ilbc. Default value is 97. The valid range is between 96 an d 127.
Conference URI
Configure the conference URI when using Broadsoft N-way calling feature.
Special Feature
Default is Standard. Choose the selection to meet special requirem ents from Soft
Switch vendors.
After the user makes a change to the configuration, press the “Update” but ton in the Configuration Menu.
The web browser will then display a message windo w to conf irm saved changes.
We recommend rebooting or powering cycle the IP phone after savi ng changes.
REBOOTING THE PHONE REMOTELY Press the “Reboot” button at the bottom of the configuration menu to rebo ot the phone remotely. The web
browser will then display a message window to confirm that reboot is under way. Wait 30 seconds to l og in
again.