Grandstream Networks HT502 user manual Way Conferencing, Fax Support, Attended Transfer

Note: continuous busy tone does not indicate the transfer has been successful, nor does it indicate the transfer has failed. It often means there was a failure to receive second NOTIFY – check firmware for most recent release.

Attended Transfer

Assume that Caller A and B are in conversation. Caller A wants to Attend Transfer B to C:

1.Caller A presses FLASH on the analog phone for dial tone.

2.Caller A then dials Caller C’s number followed by # (or wait for 4 seconds).

3.If Caller C answers the call, Caller A and Caller C are in conversation. Then A can hang up to complete transfer.

4.If Caller C does not answer the call, Caller A can press “flash” to resume call with Caller B.

NOTE: When Attended Transfer fails and A hangs up, the HT502 will ring back user A to remind A that B is still on the call. A can pick up the phone to resume conversation with B.

3-Way Conferencing

The HT502 supports Bellcore style 3-way Conference.

Instructions for 3-way conference:

Assume that call party A and B are in conversation. Caller A(HT502) wants to bring third Caller C into conference:

1.A presses FLASH (on the analog phone, or Hook Flash for old model phones) to get a dial tone.

2.A dials C’s number then # (or wait for 4 seconds).

3.If C answers the call, then A presses FLASH to bring B, C in the conference.

4.If C does not answer the call, A can press FLASH back to talk to B.

5.If A presses FLASH during conference, C will be dropped out.

6.If A hangs up, the conference will be terminated for all three parties when configuration “Transfer

on Conference Hangup” is set to “No”. If the configuration is set to “Yes”, A will transfer B to C so that B and C can continue the conversation.

Fax Support

HT502 supports FAX in two modes: 1) T.38 (Fax over IP) and 2) fax pass through. T.38 is the preferred method because it is more reliable and works well in most network conditions. If the service provider supports T.38, please use this method by selecting Fax mode to be T.38 (default). If the service provider does not support T.38, pass-through mode can be used.

Grandstream Networks, Inc.	HT-502 User Manual	Page 12 of 32
	Firmware Version 1.0.4.2	Last Updated: 06/2011