Grandstream Networks HT503 user manual Http/Https, Acs Url

Via HTTPS	The URL of the HTTP server used for firmware upgrade and configuration via a secure HTTP
	connection.
	For example, https://provisioning.mycompany.com
	Note: the HTTPS default port is 443.
Firmware Server	IP address or domain name of firmware server.
Path
Config Server Path	IP address or domain name of configuration server.
XML Config File	The password used for encrypting the XML configuration file using OpenSSL.
Password	This is required for the phone to decrypt the encrypted XML configuration file.
HTTP/HTTPS User	The user name for the HTTP/HTTPS server.
Name
HTTP/HTTPS	The password for the HTTP/HTTPS server.
Password
Firmware File	Default is blank. If configured, HT503 will request the firmware file with the prefix. This
Prefix	setting is useful for ITSPs. End user should keep it blank.
Firmware File	Default is blank. End users should keep it blank.
Postfix
Config File Prefix	Default is blank. End users should keep it blank.
Config File Postfix	Default is blank. End users should keep it blank.
Automatic Upgrade	Choose “Yes” to enable automatic upgrade and provisioning.		When set to No, HT503 will
	only do upgrade once at boot up.
	When “Check every day” or “Check every week” is checked, user can specify “Hour of the
	day(0-23)” or “Day of the week(0-6)”. Default time is Monday 1AM.
	There are three options to choose from: “Always check for New Firmware at Boot up”, “Check
	New Firmware only when F/W pre/suffix changes”, and “Always Skip the Firmware Check”.
Authenticate Conf	This protects the configuration from an unauthorized change. If set to “Yes, the configuration
File	file is authenticated before acceptance.
Firmware Key	Key for firmware encryption. (32 digits in hexadecimal format. End users should keep it blank.
SSL Certificate	The user specified SSL certificate used for SIP over TLS in X.509 format.
SSL Private Key	The user specified SSL private key used for SIP over TLS in X.509 format.
SSL Private Key	User specified password to protect the private key above.
Password
ACS URL	User specify the Auto Configuration Server’s URL (TR-069 protocol)
ACS Username	User specify the ACS Username
ACS Password	User specify the ACS password
Periodic Inform	Default is No. If set to YES, device will send inform packets to the ACS
Enable
Periodic Inform	Frequency that the inform packets will be sent out to the ACS
Interval
Connection	Set a user name for the ACS to connect to this device
Request Username
Connection	Set a password for the ACS to connect to this device
Request Password
System Ring	Configuration option for FXS port ring cadence for all incoming calls. (Syntax: c=on1/off1-
Cadence	on2/off2-on3/off3; [...])
Call Progress	Using these settings, users can configure tone frequencies according to their preference. By
Tones	default they are set to North American frequencies.
	These tones should be configured with known values to avoid uncomfortable high pitch
	sounds. ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In
	order to set a continuous tone, OFF should be zero. Otherwise it will ring ON ms and a pause
	of OFF ms and then repeat the pattern.
	Example for North America Dial Plan:
	f1=350@-13,f2=440@-13,c=0/0;
	Syntax: f1=freq@vol, f2=freq@vol, c=on1/off1-on2/off2-on3/off3; [...]
Grandstream Networks, Inc.		HT503 User Manual	Page 23 of 38
		Firmware 1.0.4.2	Last Updated: 06/2011