Energy Recovery Wheel Maintenance
Annual inspection of the energy recovery wheel is recommended. Units ventilating smoking lounges and other
Accessing the Energy Recovery Wheel
Disconnect power to the ERVe. Open door labeled “Energy Wheel Cassette Access”.
Unplug the wheel drive motor.
Pull the wheel cassette halfway out.
Removing the Energy Recovery Wheel Segments (stainless steel rim)
Steel retainers are located on the inside of the wheel rim. Push the retainer towards the center of the wheel, then lift up and away to release segments.
| Bracket Segment |
| Retainer |
| Lift away from |
| segment |
Catch Segment |
|
Retainer | Inside of wheel rim |
| Spoke |
| Push toward center |
Important! Place retainers back in the original position before rotating the energy recovery wheel, otherwise damage to retainer will occur.
Wheel segment removed
Cleaning the Energy Recovery Wheel
If the wheel appears excessively dirty, it should be cleaned to ensure maximum operating efficiency. Only excessive buildup of foreign material needs to be removed. Discoloration and staining of energy recovery wheel does not affect its performance.
Thoroughly spray wheel matrix with household cleaner such as Fantastik® or equivalent. Gently rinse with warm water and using a soft brush remove any heavier accumulation. A detergent/water solution can also be used. Avoid aggressive organic solvents, such as acetone. The energy recovery wheel segments can be soaked in the above solution overnight for stubborn dirt or accumulation.
After cleaning is complete, shake the excess water from the wheel or segments. Dry wheel or segments before placing them back into the cassette. Place wheel or segments back into cassette by reversing removal procedures.
CAUTION
Do not clean energy recovery wheel segments with water in excess of 140ºF (60ºC).
Do not dry energy recovery wheel segments in air in excess of 140ºF (60ºC).
The use of a pressure washer to clean segments is not recommended. Damage could result.
Energy Recovery Wheel Belt
Inspect belts each time filters are replaced. Belts that look chewed up
or are leaving belt dust near the motor pulley may indicate a problem with the wheel. Be sure to inspect wheel for smooth and unrestricted rotation. If a belt requires replacement, contact the local Greenheck representative. Instructions
for replacement will ship with the new belt.
Energy Recovery Wheel Bearing
In the unlikely event that a wheel bearing fails, the bearing is behind
a removable plate on the wheel support beam. Contact the local Greenheck representative for detailed instructions on how to replace the bearing.
Wheel Bearing
Model ERVe Energy Recovery Unit 25
