Greenheck Fan PVE-35, PVE-55, PVE-20 Sensors Mounted by Factory, Drawing Terminal Strip Labels

Sensors Mounted by Factory

Factory mounted temperature, pressure, and current sensors are available in the locations indicated on the unit diagram below. A list of available sensors is shown below. The specific sensors provided on a given unit are labeled in the unit control center on the terminal strip. Sensors are wired to the terminal strip to make it easy for the controls contractor to connect the Building Management System for monitoring purposes.

	OAF-P
FROM	OA
OUTSIDE	FILTER

RAI

FROM

INSIDE

OAI

RAF-P

RA

FILTER

	P	OAP
		-
-
		P
EP

PLATE

HEAT

EXCHANGER

EAP EF-A

TO

OUTSIDE

EXHAUST

BLOWER

OAAP OAF-A

TO

INSIDE

SUPPLY

BLOWER

OAD

Temperature Sensors - 1K Ohm RTD

Drawing	Terminal Strip Labels
Labels
OAI	OA/Supply Inlet Temp
OAAP	OA After Plate Temp
RAI	RA/Exhaust Inlet Temp
EAP	Exhaust After Plate Temp
OAD	Supply Discharge Temp

Pressure Sensors (analog or digital)

Drawing	Terminal Strip Labels
Labels
OAF-P	OA Supply Filter Pressure
RAF-P	RA Exhaust Filter Pressure
EP-P	Exhaust Plate Pressure
(2 sensors)
OAP-P	Outdoor Air Plate Pressure
(2 sensors)

Amp - Current Sensors (analog or digital)

Drawing	Terminal Strip Labels
Labels
EF-A	Exhaust Fan Amps
OAF-A	Supply Fan Amps

Model PVe Heat Recovery Unit 17