Installation
WARNING
ELECTRIC SHOCK HAZARD!
Installation of this appliance should be performed by qualified service personnel only. Improper installation could result in electrocution.
Set-Up/Position
1)Remove the brewer from the packing material and attach its legs.
2)Position the brewer on a strong, stable table or counter. Check the level front to back and side to side. Adjust the legs to the correct level.
IMPORTANT:
THE PERSON INSTALLING THIS APPLIANCE IS RESPONSIBLE FOR ENSURING THAT ELECTRIC AND WATER CONNECTIONS MEET THE REQUIREMENTS OF THE NATIONAL ELECTRIC CODE, NATIONAL PLUMBING CODE, AND ANY LOCAL ORDINANCES.
The electric and water
Water Hook-up
1)The water line may enter through holes on the rear or the bottom of the brewer. Use the right hand opening for water.
2)Use 3/8” copper or flexible water line to prevent strain. Do not use low temperature plastic tubing. The connection to the fill valve is 3/8” flare.
3)Water line pressure must be from 30 to 80 psi
4)Hot (up to 160°F/71°C) or cold water may be used. Hot water offers faster recovery between brews.
5)Install a
6)Installing a filtering system can improve the taste of brewed coffee and extend the life of the brewer. If your water has high calcium (lime), chlorine, or iron content, this is especially important. The filter should be the lime inhibiting type if cold water is used.
Page 4 | Shuttle Brewers & Airpot/Shuttle Brewers |