Dometic RM 7605 L, RM 7651 L, RM 7655 L, RM 7601 L Installation recess, Securing the refrigerator

6.5Installation recess

The refrigerator must be installed draught-free in a recess (see “6.2”). The measurements of the recess are given in the table below.

Push the appliance far enough into the recess until the front edge of the refrigerator casing is flush with the front of the recess. Allow a gap of 10-20 mm between the back wall of the recess and the refrigeration unit. The floor of the recess must be level, allo- wing the appliance to be pushed easily into its correct position. The floor must be sub- stantial enough to bear the weight of the appliance (no hollow space underneath).

Ensure that the refrigerator is installed level in the recess.

Recess measurements: Width of recess = W

Width of recess = W

Model	Hight H	Width W	Depth T
RM 7601 / RM 7605	1248 mm	530 mm	510 mm
RM 7651 / RM 7655	1248 mm	530 mm	510 mm

H

T

Stopper strips for example are affixed in the installation bay, at the sides, at the bottom and at the top and are fitted with flexible sealant strips

Affix strip to side wall. Seal i.e.V seal.

plan view

6.6Securing the refrigerator

In the sidewalls of the refrigerator, there are four plastic sleeves with screws for securing the refrigerator. The sidewalls or rails attached for securing the refrigerator must be designed in such a way that the screws will remain firmly in place even when under increased load (while the vehicle is moving).

Always insert screws through the sleeves provided; otherwise, structural parts embedded in the foam, such as cables, etc., may be damaged.

Once the refrigerator is in its final position, secure the screws into the wall of the recess.

The screws must penetrate through the sheet metal casing of the refrigerator.

22