Grizzly G0450 instruction manual Test Run, Recommended Adjustments

Test Run

Now that the machine is connected to the power source, it is important to perform a test run to make sure all the controls are working properly.

Before starting the sander, make sure you have performed the preceding assembly and adjustment instructions, and you have read through the rest of the manual and are familiar with the various functions and safety issues associated with this machine. Failure to follow this warning could result in serious personal injury or even death!

To test run the sander:

1.Put on safety glasses and make sure any bystanders are out of the way and also wear- ing safety glasses.

2.Rotate the red EMERGENCY STOP button until it springs up.

3.Press the conveyor START button.

—If any problems occur, press the EMERGENCY STOP button.

—For Model G0450 only: If the conveyor belt is rotating backwards, disconnect the sander from power and exchange wires L1

&L3 in the control panel.

4.Press the SANDING DRUMS START but- ton.

—If any problems occur, press the EMERGENCY STOP button.

Investigate and correct any problems before operating the machine further. If you need help, refer to the Troubleshooting section in the back of this manual or contact Tech Support at (570) 546-9663.

-20-

Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.

However, because of the many variables involved with shipping, some of these adjustments may need to be repeated to ensure optimum results. Keep this in mind as you start to use your new drum sander.

Step-by-step instructions for these adjust- ments can be found in SECTION 7: SERVICE ADJUSTMENTS.

1.V-Belt Service (Page 30). Perform after the first 16 hours.

2.Conveyor Tensioning & Tracking (Page 32).

3.Drum Adjustments (Page 33).

4.Pressure Roller Height (Page 36).

5.Dust Scoop Position (Page 37).

G0449/G0450 37" Drum Sander