Table Lift Screws
Tools Needed: | Qty |
Hex Wrench 8mm | 1 |
Wrench/Socket 14mm | 1 |
Flat Head Screwdriver | 1 |
Chalk, | 1 |
The table lift screws are connected by a chain and driven by the table elevation handwheel. When the chain is removed from a sprocket on one of the lift screws, that lift screw can adjust that portion of the table up/down independently to assist in setting the table parallel to the drums.
Adjusting the table lift screws will only be neces- sary if you need to adjust the drum heights more than allowed at the pillow bearing adjustments, or if you have removed the table or chain during a service procedure and you need to reset the drums parallel to the table.
Each tooth on the sprocket represents 0.006" or
.16mm of table elevation movement. For example, if the rear of the table was 0.006" low, rotate both rear table lift screws to the next sprocket tooth in the same chain position. You can easily rotate the sprockets from the top of the table lift screws with a flat head screwdriver.
To adjust the table lift screws:
1.Disconnect power to the sander!
2.Open the side cover.
3.Raise the table up to at least the 1" mark on the height scale.
4.At the lift screw that needs to be adjusted, mark the end of a sprocket tooth and the chain hole where that tooth is meshed, as shown in Figure 42.
NOTICE
Marking the chain and sprocket locations will save you a substantial amount of time when you reinstall the chain. Make sure you have done this before removing the chain.
