SECTION 2: CIRCUIT REQUIREMENTS

110V Operation

Serious personal injury could occur if you connect the machine to power before com- pleting the setup process. DO NOT connect the machine to the power until instructed later in this manual.

Electrocution or fire could result if machine is not grounded and installed in compliance with electrical codes. Compliance MUST be verified by a qualified electrician!

Full Load Amperage Draw

This machine draws the following amps under maximum load:

Amp Draw

14 Amps

Power Supply Circuit Requirements

The power supply circuit for your machine MUST be grounded and rated for the amperage given below. Never replace a circuit breaker on an exist- ing circuit with one of higher amperage without consulting a qualified electrician to ensure compli- ance with wiring codes. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared circuit, con- sult a qualified electrician.

Minimum Circuit Size

20 Amps

Power Connection Device

The Model G0462 comes prewired with a NEMA 5-15 plug, as shown in Figure 2.

GROUNDED

5-15 RECEPTACLE

Grounding Prong

5-15 PLUG

Neutral Hot

Figure 2. NEMA 5-15 plug and receptacle.

Extension Cords

Using extension cords may reduce the life of the motor. Instead, place the machine near a power source. If you must use an extension cord:

Use at least a 14 gauge cord that does not exceed 50 feet in length!

The extension cord must also have a ground wire and plug pin.

A qualified electrician MUST size cords over 50 feet long to prevent motor damage.

G0462 Wood Lathe (Mfg. Since 3/10)

-9-

Page 11
Image 11
Grizzly G0462 owner manual Circuit Requirements, 110V Operation