5.Insert the tapered end of the center into the spindle, then push it in with a quick, firm motion (see Figure 23).
Spur Center
Figure 23. Inserting spur center into spindle.
6.Make sure the center is securely installed by attempting to pull it out by hand—a properly installed center will not pull out by hand.
To remove the spur center:
1.DISCONNECT LATHE FROM POWER!
2.Hold a clean rag under the spindle or wear a glove to catch the center when you remove it.
3.Insert the knockout tool through the outboard end of the spindle and firmly tap the center until it breaks loose (see Figure 24).
Knockout Tool
Figure 24. Removing spur center using the
knockout tool.
G0462 Wood Lathe (Mfg. Since 3/10)
Before beginning any turning operation that uses the live center installed into the tailstock quill, make sure the spur and live centers are properly aligned (refer to Aligning Centers on Page 33 for detailed instructions). Failure to head this warning could result in the workpiece being thrown from the lathe, resulting in death or serious personal injury.
Installing/Removing
Live Center
The MT#2 live center installs into the tailstock quill and rotates with the workpiece.
To install the live center:
1.Move the tailstock a safe working distance from the head and tool rest.
2.Loosen the quill lock lever, then rotate the quill handwheel clockwise until the quill extends out from the tailstock about 1", as shown in
Figure 25.
Quill
Live Center
Quill
Lock Lever
