SECTION 2: CIRCUIT REQUIREMENTS

220V 3-Phase

Operation

Serious personal injury could occur if you connect the machine to power before com- pleting the setup process. DO NOT connect the machine to the power until instructed later in this manual.

Electrocution or fire could result if machine is not grounded and installed in compliance with electrical codes. Compliance MUST be verified by a qualified electrician!

Full Load Amperage Draw

Amp Draw at 220V 3-Phase

6.23 Amps

Power Supply Circuit Requirements

You MUST connect your machine to a grounded circuit that is rated for the amperage given below. Never replace a circuit breaker on an existing cir- cuit with one of higher amperage without consult- ing a qualified electrician to ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or you plan to con- nect your machine to a shared circuit, consult a qualified electrician.

Minimum Circuit Size (220V 3-Phase)... 15 Amps

Power Connection

The power connection device depends on the type of installed or planned service. We recom- mend using a NEMA15-15 plug and receptacle shown in Figure 2.

<gdjcYZY

DjiaZi7dm

8jggZci

8Vggn^c\

7aVYZh

<gdjcY^c\E^c

Figure 2. NEMA 15-15 plug and receptacle.

Extension Cords

Using extension cords may reduce the life of the motor. Instead, place the machine near a power source. If you must use an extension cord:

Use at least a 14 gauge cord that does not exceed 4 meters in length.

Ensure that the extension cord contains a ground wire and plug pin.

NOTICE

This machine uses sensitive electronics that rely on stable current on all power supply legs. We do not recommend connecting this machine to a phase converter. Ignoring this notice may void warranty.

-10-

READ ELECTRICAL SAFETY

G0648 Welding Fume Extractor

 

ON PAGE 36!

 

Page 12
Image 12
Grizzly G0648 owner manual Circuit Requirements, 220V 3-Phase Operation