2.Locate the cap screws indicated in Figure 43. Loosen the upper screws one half turn and the lower screws 2 full turns. DO NOT remove these screws.
Loosen Slightly
Loosen
Set Screw
Figure 43. Blade tracking adjustments.
3.Turn the bandsaw ON. Keep the saw frame locked in the starting position.
4.While watching the space between the blade and wheel flange, turn the set screw coun- terclockwise. This will move the blade away from the flange. As soon as the blade begins to move away from the flange, turn the set screw as necessary to stabilize the blade approximately 1⁄8" from the flange.
5.Slowly turn the set screw clockwise to move the blade back towards the flange. When the blade is running up against, but not touching the flange, turn the set screw as necessary to stabilize the blade tracking.
6.Turn the bandsaw OFF.
7.Tighten the cap screws, then recheck the blade tracking. If the tracking needs further adjustment, repeat Steps 4-7 until the track- ing is correct.
9.Close the upper wheel cover.
Note: For the best performance from your saw, regularly maintain proper blade tracking.
NOTICE
Changes in the blade tension may change the blade tracking.
Changing Speeds
The Model G0659 has four blade speeds. These speeds are determined by the position of the
| <:6G7DM |
| |
| EJAA:N |
| |
| 7:AI | 7A69: | |
6 | EDH>I>DC | HE::9 ;EB | |
6 | |||
7 | |||
8 | 7 | ||
9 | 8 | &)% | |
| 9 | ||
BDIDG |
| ||
EJAA:N |
| ||
Figure 44. Belt positions.
To change the blade speed:
1.DISCONNECT BANDSAW FROM POWER!
2.Release the saw frame and allow it to come to rest in the forward position.
3.Remove the right side access cover to expose the motor, gearbox, belt and pulleys.
4.Lift up on the motor to release tension from the belt. While still lifting the motor, reposition the belt in the desired position, then carefully lower the motor.
5.Turn the belt by hand to make sure it is prop- erly seated in the pulley grooves.
6.Replace the right side access cover.
G0659 9" x 14" Vertical
