Lower Blade Guide Assembly Adjustment
When it is not possible to accomplish the neces- sary blade guide positioning with the eccentric spindles alone, the entire blade guide assembly must be
To position the lower blade guide assembly:
1.DISCONNECT BANDSAW FROM POWER!
2.Move the saw frame forward until it is up to, but not yet entering the slot in the table, as shown in Figure 37, then lock the frame in place using the saw frame stop clamp.
| Saw Frame Stop Clamp |
Blade Guard Cap Screw | |
| Blade Guard |
Blade | Table |
Slot | |
Figure 37. Blade guide setup.
3.Open the upper wheel door, loosen the blade guard cap screw and remove the blade guard.
4.Loosen set screws A, B, and C on the lower blade guide assembly (Figure 38).
Set Screw B |
Set Screws C |
Set Screw A |
Figure 38. Lower blade guide assembly.
5.Wearing gloves, hold the blade in-line with the path of the saw and centered over the slot in the table. Rotate the eccentric shaft so the blade guide assembly is centered over the blade, as shown in Figure 39, then tighten set screw A.
Hadi | IVWaZ | |
| ||
| 7aVYZ | |
| >c"a^cZL^i]EVi] | |
| D[HVl | |
8ZciZgZY |
| |
7aVYZ<j^YZ | :XXZcig^XH]V[i | |
6hhZbWan | ||
| ||
| HZiHXgZl6 |
Figure 39. Lower blade guide.
6.Rotate the blade guide assembly and apply just enough pressure to hold the blade flat against both guide rollers. Rotate the eccen- tric spindles so their slots are oriented verti- cally, as shown in Figure 40. This positions the blade guides in the center of their range of motion to facilitate later adjustments.
7.Tighten set screws C.
7aVYZ<j^YZ |
;aVc\Z |
HZiHXgZl7 |
:XXZcig^X |
He^cYaZh |
HZiHXgZlh8 |
